NanoEnergizer FAQ

Nano Energizer is Revolutionary & Patented Platinum Coated Nano Ceramic Material for easy Restoration, Repair and Protection of any Engine, Gearbox, and Mechanical Machine that uses lubrication.

No.Engine or Oil Treatment basically only provide an additional layer of lubrication between the Engine Cylinder Wall and Pistons for extra protection during Engine Usage. They do not coat or restore worn out engine cylinders.

Nano Energizer contains Platinum which is proven scientifically to improve combustion inside Engine Cylinders. Improvement in combustibility will indirectly improve fuel efficiency due to less wastages of unburned fuel.

The Nano Ceramic(Zirconium) coated with Platinum are 20 X Stronger and has a higher Wear and heat resistance than a typical Engine Block Material. Nano Energizer bonds to cracked or worn engine wall through heat and pressure.

Any types of Petrol, Diesel or NGV engines (Cars, Motorcycle, Lorry, Busses, etc), Generators, Gearboxes or any mechanical machines that uses oil for lubrication..

Diesel Vehicles: Coating starts from 500km and fully coated at 2000km
Petrol Vehicles: Coating Starts from 500km and fully coated at 1500km
Motorcycle (Below 650cc): coating starts from 100km and fully coated at 1000km
NGV Vehicle: Coating starts from 100km and fully coated at 1000km

Yes. Nano Energizer has been extensively tested by various testing facilities, car manufactures and individuals.To date, all of results are positive and proven effective. Do read the testimonials here or visit www.facebook.com/nanoenergizermalaysia for more info

Nano Energizer can be poured directly into the Engine Block right after an Engine Oil Change or not more than 3000km after the most recent oil change.

NO. You just need to ensure that Nano Energizer has completed its coating cycle (approximately 1000-2000km) before you replace the oil. You only need to reapply Nano Energizer after every 30000 - 40000 km to maintain the optimum benefits. Always follow engine manufactures oil requirements and changes.

Engine Less than 2000cc = 1 packet of NanoEnergizer All In One (Car)

Engine 2000cc and above = 2 packets of NanoEnergizer All In One (Car)

Diesel Engine & V6 Engine = 2 packets of NanoEnergizer All In One (Car)

SuperBike Engine more than 500cc = 1 packets of NanoEnergizer All In One (Car)

Motorcyles Engine less than 500cc = 1 packets of NanoEnergizer Small Engine (Motorcycle)

Step 1 : Warm up your engine for 5 minutes
Step 2 : Shake NanoEnergizer 30ml vigorously for 2-3 minute. Ensure that there is no feeling of hard particles on the inner edges of the sachet. Continue to shake until all the nano ceramic material is evenly dispersed.
Step 3 : Pour the whole content into the engine
Step 4 : Drive your vehicle for a few kilometers.

* You may start to feel the difference as soon as 200-500km but full coating only occurs after reaching 1000km for petrol engine, 1500km for diesel engine or 500km for NGV Engine.

** Use NanoEnergizer AFTER CHANGING ENGINE OIL OR NOT MORE THAN 3000KM AFTER CHANGING ENGINE OIL

NanoEnergizer All In One - RM110/sachet + Pos Laju
NanoEnergizer Small Engine - RM95/sachet + Pos Laju

NOTE: You only need to reapply Nano Energizer after every 30000 - 40000 km to maintain the optimum benefits. Approximately about after every 3 times oil change or only once a year!

Consumer - You may buy direct from our website by clicking here. WHOLE SALE - If you are looking at treating a large number of trucks and a fleet, do contact us for a special discount on bulk purchases.